How to use a red light therapy mask at home, step by step

Use a red light therapy mask on clean, dry skin with your eyes closed and the eye shields in, for 10 to 15 minutes, 3 to 5 times a week. Start on a low brightness for 10 minutes, and stop if your skin burns, itches or feels uncomfortable. This guide follows the instructions of the Vitarest red light therapy mask.

Before your first session

  • Charge the controller fully with the USB cable (4 to 5 hours). Never use the mask while it charges.
  • Peel off any protective film and fit the eye shields into the eye openings.
  • Read who should not use an LED mask. If you are pregnant, have epilepsy, are sensitive to light or take medication that makes your skin sensitive to light, do not use it.
  • Try the light on the inside of your arm for 1 minute and wait. If your skin itches or turns very red, do not use the mask.

Your session, step by step

  1. Clean your face. Remove make-up and pat your skin dry. Some skincare and make-up ingredients react with light.
  2. Fit the mask. Hold it by the edges, place it on your face and adjust the two head straps so it sits close without pressing.
  3. Close your eyes. Keep them closed for the whole session and never look into the LEDs.
  4. Switch on. Connect the mask to the controller, then press and hold the power button for 1 to 2 seconds. It starts in red light.
  5. Choose your settings. The M button changes the colour mode, the NIR button adds near-infrared (850 nm), the E button sets brightness (3 levels), and T+ or T- sets the timer (10, 20 or 30 minutes).
  6. Relax. Sit or lie down. The mask switches itself off at the end of the timer.

How long and how often

The instructions recommend 10 to 15 minutes per session, 3 to 5 times a week. Start at brightness level 1 or 2 for 10 minutes and only increase if your skin is comfortable. Longer or brighter sessions are not better. Slight redness that fades within 1 to 2 hours is common; anything stronger is a sign to stop.

Which light to choose

  • Red (620 to 630 nm): the mode most people use, and the default when you switch on.
  • Near-infrared (850 nm): invisible to the eye, switched on with its own button, alone or with red.
  • Blue, green and mixed modes: available if you want to try them, on the same timer and brightness settings.

After the session

  • Apply your usual moisturiser.
  • Avoid strong direct sunlight on your face straight afterwards.
  • Switch off, unplug, and wipe the inside of the mask with a soft, slightly damp cloth. Let it dry. Never put it in water.
  • Store it flat in its pouch, away from heat and children.

Questions

Can I use it every day?

The instructions recommend 3 to 5 sessions a week. Leave rest days between sessions.

Can I watch TV or look at my phone during a session?

No. Your eyes must stay closed. Listen to music or a podcast instead.

Does it replace my skincare?

No. It is an extra step in your routine, and results vary from person to person.

More: all Vitarest guides, our Light collection, 30-day returns.

Beauty and personal care product, not intended to diagnose, treat or prevent any condition.